The Motobilt Jeep TJ full length rocker guards made in the USA extend from the front fender all the way to the rear wheel well opening. We laser cut the rocker guards from 3/16 inch high strength steel. Our rocker guards are formed so that they wrap underneath the body of your jeep and tie into the factory body mounts.

This setup allows for use with the Motobilt Jeep TJ factory cut corners. (MB1055) We also slot the lower portion of the rocker guards to make it easy to clean out your rockers after a hard day of wheeling.

Compatible Corner Guards:

• MB1055 Factory Cut Corner Guards
• MB1057 Blank Corner Guards

Notes:

• Drill Bit Size: 5/16 Inch nut serts use a 17/32 Inch drill bit to install.
• Ships raw steel. Must be painted or powder coated to prevent rust.

Specifications:

• Motobilt Jeep TJ Rocker Guards are countersunk
• Hardware included. Nutserts are only used where the bolt is not accessible from the backside.
• Hardware 12- 5/16 inch counter sunk bolts with flat washers and nyloc nuts
• The proper drill size for the 5/16 inch Rivnuts is 17/32 Inch.
• Works with or without a body lift.
• Laser cut also CNC form 3/16 inch thick steel plate
• Sold as pair
• Weight: 68lbs (approx.)